XFyre® Hydronic Boilers, 300A-850A

BASIC DATA
Model
Full Input in BTUH
Flue Dia.
Cat IV Venting materials
H7-300A  300,000 4" PVC, CPVC, CentrothermR
polypropylene,
stainless steel
H7-400A  399,000  4"
H7-500A  500,000  4"
H7-700A  700,000  6"  Stainless steel only
H7-850A  850,000  6"

Features:
  • 94% Efficiency Condensing, Cat IV venting required (up to 99% at part/load).
  • All models indoor/outdoor construction.
  • Small footprint, less than 9-1/2 square feet.
  • Top side water connections - allows side by side installation.
  • All models are equipped with 316L welded stainless steel heat exchanger and copper plumbing. ASME Section IV constructed and stamped. National Board Registered AB 1953 low lead compliant.
  • Multiple pump outputs - Boiler Pump, System Pump, Indirect Pump.
  • Spark ignition with remote flame sensor.
  • Electronic modulating gas valve and burner, up to 5:1 turndown.
  • Certified under SCAQMD Rule 1146.2.  Meets all Low NOx regulations.
  • Supports inlet water temperature down to 50F.
  • Whisper quiet operation.
  • On-board diagnostic center, English, no codes.
  • 0-10 VDC BMS Interface (setpoint or direct drive).
  • Built-in cascade function for up to 4 boilers.
  • VERSA IC® control package with built-in outdoor reset function.
  • Complete cabinet protects all controls and wiring.
  • Tough rust-resistant powder coat finish.
  • Easy to service - removable air filter.
  • Certified for PVC, CPVC, Polypropylene or stainless vent materials.
  • Suitable for altitudes up to 10,000 ft. (derate may apply).
  • Available for natural gas or propane.
Options:
  • Outdoor air sensor (B-32).
  • Indirect sensor.
  • TruSeal® direct vent kit (D-21 factory installed, D-22 Loose).
  • BACNet IP, BACnet MS/TP, Modbus TCP, N2 Metasys (B-85)
  • Lonworks (B-86)
  • Alarm with 4” Bell (E-5)
  • Low Water Cutoff (F-10)
  • Condensate neutralizer (Z-12).

Specifications

Warranties

Documents